products
[Introduction]: A slurry pump with wear and corrosive resistance.
[Capacity]: Flow≤3798m³/h
[Improvement]: Slurry pump with resistance to wear rubber, corrosion and impact is made of high hardness alloy cast iron.
Before slurry pump launching, driven by a motor, the absorption pipe and pump are full of liquid. When impeller rotates at high speed, the liquid among impeller rotates with it as well. Because of the centrifugal force, the liquid is thrown to the other edge of the impeller from the center, the kinetic energy increasing as well. When the liquid enters the case of pump, the liquid flow speed gradually reduces because the runner in volute-shaped pump housing enlarges. A part of kinetic energy turns into hydrostatic energy. The liquid outflows at higher pressure. At the same time, the impeller center creates a vacuum because of the liquid outflow. The pressure on the impeller sufrace is higher than the center of impeller. Therefore, the liquid adsorbed into pipe enters pump under differential pressure. The impeller rotates, and the liquid is adsorbed and pinched out.
| Size range (outlet) | Flux | Lift |
| 50mm~350mm | Up to 3798m3/h | Up to 118m, 60m on average |
To find out more about our products and solutions, please fill out the form below and one of our experts will get back to you shortly.
CHAT
MESSAGE
